Forum
Notifications
Clear all
Topic starter
18/06/2021 4:48 pm
Do you guys have any kind of guide on how to clean water soluble pieces after dissolving the support?
16/07/2021 12:09 pm
To clean it you can use a sponge or something similar to clean the remaining material. Rub the model with hot water until it is clean.
Be careful when using hot water, materials like PLA and Tough PLA can be deformed by the temperature. For these materials, the water can't be hotter than 60ÂșC.
To speed up the dissolving process you can use hot water.