Find a Reseller  <https://www.bcn3d.com/reseller/?fwp_paises=es data-src="/>
Book a Demo <https://3d.bcn3d.com/schedule-a-demo-with-bcn3d-technologies data-src="/>

Workbench Series

Desktop Series

Peripherals

 
 

Technical

 

Forum

NEED A BETTER BED F...
 
Notifications
Clear all

NEED A BETTER BED FOR EPSILON W50 COME HERE


mlaurin
(@mlaurin)
Eminent Member Customer
Joined: 1 year ago
Posts: 49
Topic starter  

I have contact Wham Bam to make a custom spring steel bed for a epsilon W50 here is the reply:

Thank you for reaching out.      

We currently do not have anything close enough to fit that printer but we are always looking for new sizes that are in demand. In general, we wait until we get about 20 people interested in any size before we open it. Here is our new size request form for the FBS for FDM: http://eepurl.com/dLES_Y

Please let me know if I can assist you with anything else.

 

Kind regards,

Cesar


Quote
matthew.reynolds
(@matthew-reynolds)
New Member Customer
Joined: 1 year ago
Posts: 2
 

@christian-berger

Do you want to add some pictures of the custom CR3D PEI flexi-plate we had made?


ReplyQuote
christian.berger
(@christian-berger)
Active Member Customer
Joined: 1 year ago
Posts: 15
 

We had the same wish, so we asked at cr3d in Germany. They made a swap for us for the bcn3d w50. We bought some double sided sheets (smooth and textured)and some magnetic sheet. We sticked the magnet foil to a glass bed. All original mounting points work, we can swap back if we want to.  Go to www.cr3d.de and contact the guy if you need that too

 

@matthew-reynolds

 

 


mlaurin liked
ReplyQuote
igor.sheinfeld
(@igor-sheinfeld)
New Member Customer
Joined: 8 months ago
Posts: 2
 

@christian-berger

is there a cutout for the self-clibration square on the sheets?


ReplyQuote
christian.berger
(@christian-berger)
Active Member Customer
Joined: 1 year ago
Posts: 15
 

@igor-sheinfeld no, 

the sheet we have here are made with a drawing from our side

the bed that we used did not had those cutout in the center because our machine is not able to do that calibration mode
we ordered our machine last year but probably got one of the last ones without that self calibration

 

i think if you measure the cutout position and give that data to CR3D they can adjust their DXF ang make sheets for that.
im not sure but i think that shout work as well


ReplyQuote
dario
(@dario)
Active Member Customer
Joined: 11 months ago
Posts: 6
 

If it could be used on sigmax r19 i would be interested.


ReplyQuote