Forum
Notifications
Clear all
Topic starter
25/02/2022 10:41 am
Using the BCN TPU Filament I get better results in decreasing the Flow rate from 115% to 100%. Before that I had often problems with clogging.
Topic starter
07/04/2022 5:30 pm
What's also necessary, is to decrease the "Retraction Distance" from 8 (default) to 1. Using 8 leads to clogging after short time on my prints.
25/04/2022 1:42 pm
@rango Do not forget to do a cleanup process if you have use other material before. Its append to me 🤣 but you right basic profile need real good improvement to work correctly whiteout this type of problem. I am pretty shure that you keep your filament safe from humidity 😉