Find a Reseller  <https://www.bcn3d.com/reseller/?fwp_paises=es>
Book a Demo <https://3d.bcn3d.com/schedule-a-demo-with-bcn3d-technologies>

Workbench Series

Desktop Series

Peripherals

 
 

Technical

Composites

 

Forum

Sigma D25 not stori...
 
Notifications
Clear all

Sigma D25 not storing calibrations


croft
(@croft)
New Member Customer
Joined: 1 month ago
Posts: 2
Topic starter  

Hello everyone,

Sigma D25 appears to not store calibrations after power cycle. Every time I power off D25 and then run the same PLA filament in the same extruder I have to go through bed leveling and first layer calibration. If I do not complete this re-calibration between power cycles, then the hotend ends up to close to the glass scraping it. 

How would I go about determining if this information is stored?

 

This topic was modified 1 month ago by croft

Quote
Support BCN3D
(@support-bcn3d)
Member Admin
Joined: 2 years ago
Posts: 18
 

Hello Croft,

 

We found a bug on the version 0.17.1 that affect the calibration process, this bug is solved on the version 0.17.3 and higher: https://support.bcn3d.com/knowledge/update-firmware-bcn3d

 

best regards


ReplyQuote
Share: