1M1 – bottum cutoff

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #14978
    richard
    Participant

    Is there any reason why 1M1 does not have a flat surface? This causes the outside to be printed on support.

    If you Cutoff object buttom for 0.5mm there is no need for it.

    #15009
    Forcerouge
    Participant

    Just flip it 180 degree, the other face is flat.
    This gap acts like a track for the bearings, but turns out not to be essential

    #15879

    Good morning!
    Exactly, this small gap is a track for the bearings. If you print this part like this you will get “crunchy movements” due to irregular surface. You should flip 180 degrees!

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.