BnC3d Sigma Very Hairy Prints

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #8913
    k3d.honduras
    Participant

    Just printed with XT using curea standard setting as downloaded but like the PLA I am getting a very Hairy Triangle print. Please advise

    Layer 0.18
    Shell 1.2
    Bottom 0.8
    Speed 35
    Temp 255
    Bed 75
    Diameter 2.85
    Flow 100%
    Nozzle 0.6
    Retraction 40
    Distance 4
    Initial layer 0.4
    initial layer line 110
    Travel speed 200
    Bottom layer 20
    infill 0
    Top 0
    Bottom 0
    Outer shell 0
    Inner shell 0
    Minikin layer time 5
    Enable cooling fan
    Fan at 100%
    Retraction Travel 1.5
    Distance 4
    Combing All
    Min Extrusion 0.02
    Z Hop 1
    Cool Full at 1mm
    Fan speed 100
    Minimum Speed 10

    #8919
    roger uceda
    Moderator

    Try to decrease temp to 245.
    Retract lenght 4.5mm
    Z hoop 0 or 0.05mm also helps.
    Depending on the humidity, it’s important to keep the filament dry. Otherwise it is also a cause for stringing.
    And finally putting heatsink paste between the thermal brake and the heatsink also can improve retract.

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.