Enhancement requests

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #4153
    guido
    Participant

    Hello, just in addition to what nickkon suggested… a few things that would be nice to have at some point:

    – If there are no good reasons to do otherwise, switch off the hotend’s cooling fan as long as the hotend isn’t heated.
    – When heating up pre print, start heating up bed + hotend at the same time. Currently, the hotend only starts when the bed has reached the set temp.
    – More noise reduction measures.

    Thanks!
    gj

    #4154
    guido
    Participant

    Sorry just saw this had been suggested already – not surprising.

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.