How to fix grinding/slipping?

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #7683
    luke1
    Participant

    Hey,

    One of my motors has started to grind every almost every time I print. I’ve tried reducing the retraction but that has;t helped. I also tried doing the screw up a little as per the the maintenance (although I was;t sure how much to tighten, so didn’t do this too much as I didn;t want to damage anything. It was tighter however than the other one which is not grinding/slipping).

    So, does anyone has any ideas? Should I take it apart and maybe give it a clean? Is there any guide on this before I jump in?

    Thanks as always 🙂

    Luke

    #7690
    luke1
    Participant

    think I might have nailed this… a simple nozzle clean might have fixed. The simple solution stumped me as I’d only just cleaned the nozzle.

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.