Much more control!

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #5618
    rubin.khatib
    Participant

    hello there.. I’ve got my new sigma 2 weeks ago..
    and i’d say it’s a sturdy very well built up machine..
    but as i already have an ultimaker .. i found a huge difference when it comes to controls in general..
    especially while printing ..
    -change material while printing for example .. is a major missing thing ..
    -move print bed up or down
    -LED light controls
    – percentage of completion is not accurate at all ..

    the touch screen is slow and freezes a lot .. i wish it was a typical rotating control ..
    after the print finishes.. i can’t understand why the bed stays up and the noisy fans stays on !

    in general i think this machine is nice but it needs alot of work on the firmware..

    #5804
    roger uceda
    Moderator

    Hi Rubin,
    We are now putting all our efforts in firmware. Stay tuned because we will be upgrading soon 🙂

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.