printing at 50 microns

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #11659
    shackman0
    Participant

    all the literature claims that the sigma prints at 50 microns. however, when i try 50 microns, it barely extrudes anything. it works fine at 100 microns (high quality). i’m using simplify3d. are there some settings i need to change from high quality?

    #11673
    vlad
    Participant

    I’d suggest trying to use Cura BCN (which is free) and compare the results and settings.

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.