Pronterface & Manual Move

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #12332
    Barbecue Silver
    Participant

    Hej there!

    When I want to control the printhead of the sigma via USB with Pronterface, I can not move the left extruder correctly.
    1. Left Printhead moves a very distance when I hit the button for a “0.1” move to the right.
    2. Left Printhead moves also to the right, if I hit the button for a left move.

    The other printhead I did not test. I am currently using pronterface only, if the filament is stuck. But this is not really a solution for me.

    Printings are running mostly fine, except the other problem I described here in the forum.
    Again: I am running the latest firmware (v01-1.1.6).

    Thanks and greetings,
    BBQ

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.