right side Extruder not calibrating

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #15247
    jschwarz
    Participant

    Hi,

    got my Sigma today but I am not able to calibrate the right side extruder.

    – Bed calibration works
    – Left side calibration works
    – on the Right side the printing bed stops ca. 10mm below the nozzle and I am not able to move the bed more upwards during the calibration process so there is still a gap from roundabout 8mm.

    I already tried the M502 + M500 commands but this does not help.

    Firmware is 01-1.2.0 (Updated but previous SW was not working either) – Formatted internal Card to Fat 16 and put on new files – as I think this is for display only – wworks.

    Any ideas please?

    Many thanks

    Juergen

    #15251
    andy.seider
    Participant
    #15282
    jschwarz
    Participant

    Hi Andy,
    many thanks – that helps, but as of today the right extruder does not come to its temperature. Will switch back now to the prevoius firmware
    Juergen

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.