Temperature selection in Firmware 1.2.0?

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #14106
    3DSOS
    Participant

    I’ve just updated the firmware and when I want to preheat the printer I see that it’s not possible to set target temperatures but they come preset to 215º for extruders and 65º for the bed. Is it real? Can’t we set the temperatures to different values?

    #14146
    LimoneClaudio
    Participant

    I found a way to do it:
    Go to Utilities>Filament>Purge and you can heat up and choose the temperature for every extruder.
    The extruder will then stay on also if you leave the page (you can normally cool it down turning it off in the temperature settings).
    Unfortunately I didn’t find any similar workaround for the bed temperature.
    Hope this helps

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.