Updated Firmware to 1.2.0 and now printer won’t boot

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #16014
    subscriptions
    Participant

    I used Cura to update my Sigma’s firmware to 1.2.0 and installed the corresponding LCD files in the LCD’s microSD card (properly formatted as FAT-16), but now my printer won’t boot pass the BCN3D logo!
    The logo appears on the screen very slowly and then stays on. The version number on the bottom right shows 1.2.0, but it won’t pass that stage.
    Does anyone have an idea of what could be going on? my printer is bricked!

    Thanks in advance,

    Mauro

    #16058
    jgarison
    Participant

    Same here.

    #16060
    jgarison
    Participant

    Fixed.
    I switched the unit on without the LCD SD installed. Then turned it off and installed the SD card and it works fine now.

    #16567
    jamesballa
    Participant

    i’ve got the same issue tonight…. I tried jgarison’s suggestion but it hasn’t worked. Has anyone else gotten anywhere with this ?

    #16569
    jamesballa
    Participant

    hi guys fixed it, make sure you format to FAT first. Mines working great again.

Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.